Industrial Fans have been on the market for many years and have achieved good results. They have successfully solved ventilation and cooling problems in workshops for many listed companies and small and medium-sized enterprises, and have gained a good reputation. Customers who have installed our Industrial Fans have been installing them for more than ten years. In fact, they have been installing them for a few years or a few months. Against the background of so many installations and uses, Industrial Fans still maintain a record of zero accidents, which also makes more and more customers trust our products.
The installation of Industrial Fans has been the cause of zero accidents for more than ten years, which is inseparable from its installation and debugging. An
Industrial Ceiling Fan weighs approximately 150kg and produces approximately 260Nm of torque. As the speed of the Industrial Ceiling Fan increases, the fan blades will tilt upward at a certain angle to increase the coverage area of the Industrial Ceiling Fan. Therefore, before installing an Industrial Fans, we should measure all obstacles that may be encountered within the radius of the Industrial Ceiling Fan and between the horizontal height of the Industrial Ceiling Fan's resting position and the ceiling. There must be a gap of more than 500mm between the existing equipment or facilities, whether horizontally or vertically.
Installation using multiple fixing methods: I-beam installation → cement beam installation → universal joint installation → extension rod installation → motor installation → electrical casing and wiring → installation of safety rope around the beam → fan blade and tail installation → fan blade installation → bottom cover Install.
After installation, it is time to inspect and debug the Industrial Fans. At this time, you should recheck and ensure that all fastening bolts use the bolts, washers and locknuts configured by our manufacturer, and they must be tightened. Then check whether the wire rope around the beam is installed correctly, make sure the rope head is tight, and make sure that the four tightened wire ropes are perpendicular to the motor bracket.
Safety is no small matter. There is no room for carelessness in the installation and debugging of Industrial Fans. Every step needs to be done carefully. It is recommended not to find an outsourcing team or install it yourself. There should be direct operation by the manufacturer's personnel.
