With the development of the economy, HVLS Fans are increasingly used in factory workshops to provide ventilation and cooling effects for workshop workers. However, in the past two years, there have been more and more injuries caused by Hvls Ceiling Fans. How to install Hvls Ceiling Fans safely and securely? The following HVLS Fans manufacturer uses years of experience to summarize the installation methods of HVLS Fans to keep you away from HVLS Fans accidents.
The general installation method is: after the HVLS Fans is fixed on the ceiling, connect the live wire of the power grid to one end of the HVLS Fans speed regulator, connect one wire of the HVLS Fans to the other end of the speed regulator, and connect the neutral wire directly.
1. To cut off the circuit power, please remove the corresponding fuse or disconnect the corresponding circuit breaker. Additionally, you can operate the main switch to cut off the main power supply to the plant.
2. Remove the original lamp from the ceiling. Most light fixtures are bolted or screwed to the ceiling and can be disconnected by removing the cover.
3. Put down the lamp and disconnect the wires. Mark each wire with masking tape for easy identification later.
4. Check the manufacturer`s instructions on the HVLS Fans wiring color code and recommended installation steps. In most factories, there are two wires in the circuit and three wires in the lamp. Connect the black wire to the black wire, the white wire to the white wire, then connect the remaining ground wire (bare wire or green wire) to the metal junction box or other location recommended by the manufacturer, connect with a connecting nut, check if firm.
5. Check the wiring, consult the manufacturer's instructions, and then carefully push all wires into the junction box.
6. Connect the HVLS Fans to the junction box or hook according to the manufacturer's instructions.
7. If the light is installed under an HVLS Fans, make sure both components are of the same brand and designed to work together. Remove the bottom cover from the HVLS Fans unit and pull out the ends of any loose wires and connect them according to the manufacturer's instructions. Usually refers to the connection of black wire to black wire, white wire to white wire, ground wire to ground wire.
8. Re-energize the circuit and test the system
In fact, you can do many home appliance repairs yourself, but please be sure to take appropriate safety precautions and contact professionals promptly when necessary.
